Ricerca:
•
TEKTRONIX
Oscilloscopi
Accessori per oscilloscopi
Generatori di segnali
Analizzatori di Stati Logici
•
TTi Thurlby Thandar
Electrical Power Supplies & Converters
Test Equipment
Mechanical, Office & Workplace Computer Products & Stationery
•
Goodwill GW Instek
Alimentatori
Apparecchi di misura
Multimetri
Oscilloscopi digitali
Strumenti generatori di funzioni
•
Weinschel Associates
Fixed Coaxial Attenuators
Calibrated Attenuator Sets
Coaxial Terminations
Variable Attenuators
Power Splitters & Dividers
DC Blocks
Precision RF Adapters
Double Stub Tuners
•
Electro-Metrics
Antennas
Antenna Kit
Filters
Miscellaneous and Accessories
Networks
Receivers
Sensors
•
Solar Electronics
Antennas
Application Information
Capacitors
Coupling Networks
Essential Appartus Charts
Instruments
Line Impedence Networks
Probes
Pulse Trasformers
Resistive Devices
Trasformers
Wave Filters
Coupling Networks
7415-3 RF
Coupler and High Pass Filter, 50KHz to 400 MHz, 270 VAC
Euro 0,00
Quantità
There are those who disagree with the r.f. conducted susceptibility test setup of Method CS02 of MIL-STD-462. Homemade rigs have sprouted to comply with the coupling capacitor requirement, each with it own disadvantage. Our little Type 7415-3 R.F. Coupler is the answer. A neat little box with BNC connectors and a pair of binding posts, it is rated at 270 V.A.C. at the LINE terminals and 20 volts PMS into the GEN port. Looks good and does a fine job.
Disponibilità:
7835-891
Coupling Network, equivalent to CU-891/URM-85, 50 ohms
Euro 0,00
Quantità
When setting up a shielded room
for full compliance with EMI specifications, it is often discovered that there are incidental items which are needed, but which have not been considered in the overall planning. Some of these items are indicated
on the catalog pages under the subheading USEFUL ACCESSORIES
Disponibilità:
7835-892
Coupling Network, equivalent to CU-892/URM-85, 500 ohms
Euro 0,00
Quantità
When setting up a shielded room
for full compliance with EMI specifications, it is often discovered that there are incidental items which are needed, but which have not been considered in the overall planning. Some of these items are indicated
on the catalog pages under the subheading USEFUL ACCESSORIES
Disponibilità:
7835-896
Coupling Network, equivalent to CU-896/URM-85, 50 ohms
Euro 0,00
Quantità
When setting up a shielded room
for full compliance with EMI specifications, it is often discovered that there are incidental items which are needed, but which have not been considered in the overall planning. Some of these items are indicated
on the catalog pages under the subheading USEFUL ACCESSORIES
Disponibilità:
8614-1
Coupling Network, "Voltage Probe" for FCC v
Euro 0,00
Quantità
The Type 8012-50-R-24-BNC is a dual network for use on 120 volt d.c. or 50-60 Hz single phase power lines. It will handle up to 24 amperes of power current to the equipment under test (EUT). It is fitted with a power cord on one end and a power receptacle on the other end. The receptacle is the style used in the USA with parallel blades and a U shaped grounding pin. A rotary switch selects which of the two power leads is connected to the BNC r.f. jack for test.The unused line is terminated in a 50 ohm resistor.
Disponibilità:
9132-1 RF
Coupler and High Pass Filter, 500 VAC
Euro 0,00
Quantità
Disponibilità:
9407-1
Three Phase RF Coupling Network, 2 MHz to 30 MHz v
Euro 0,00
Quantità
Disponibilità:
Selint s.r.l., Via della Stazione di Ciampino 24, 00040 Morena (Roma) Copyright 2008
Tel. 06.79841028 - 06.79841418 Fax 06.79845254 Email: info@selint.it P.Iva 10151060158
Services and Support
Powered by:
Web Marketing Pro
, P
osizionamento
&
Email Marketing
Selint: Coupling Networks>
