Line Impedence Networks

• TEKTRONIX
    Oscilloscopi
    Accessori per oscilloscopi
    Generatori di segnali
    Analizzatori di Stati Logici
• TTi Thurlby Thandar
    Electrical Power Supplies & Converters
    Test Equipment
    Mechanical, Office & Workplace Computer Products & Stationery
• Goodwill GW Instek
    Alimentatori
    Apparecchi di misura
    Multimetri
    Oscilloscopi digitali
    Strumenti generatori di funzioni
• Weinschel Associates
    Fixed Coaxial Attenuators
    Calibrated Attenuator Sets
    Coaxial Terminations
    Variable Attenuators
    Power Splitters & Dividers
    DC Blocks
    Precision RF Adapters
    Double Stub Tuners
• Electro-Metrics
    Antennas
    Antenna Kit
    Filters
    Miscellaneous and Accessories
    Networks
    Receivers
    Sensors
• Solar Electronics
    Antennas
    Application Information
    Capacitors
    Coupling Networks
    Essential Appartus Charts
    Instruments
    Line Impedence Networks
    Probes
    Pulse Trasformers
    Resistive Devices
    Trasformers
    Wave Filters



Line Impedence Networks

Line Impedance Stabilization Networks - EMI voltage from power lines to ground

Euro 0,00

Quantità

The Solar Electronics LISNs use a series inductor between the test sample and the power source to provide the impedance-versus frequency characteristic. A coaxial connector with d.c. isolation is provided for connection to the associated frequency selective EMI meter. The power source
end of the inductor is bypassed to ground.

Disponibilità:

FCC Line Impedance Stabilization Networks |

Euro 0,00

Quantità

The Type 8012-50-R-24-BNC is a dual network for use on 120 volt d.c. or 50-60 Hz single phase power lines. It will handle up to 24 amperes of power current to the equipment under test (EUT). It is fitted with a power cord on one end and a power receptacle on the other end. The receptacle is the style used in the USA with parallel blades and a U shaped grounding pin. A rotary switch selects which of the two power leads is connected to the BNC r.f. jack for test.The unused line is terminated in a 50 ohm resistor.

Disponibilità:

Line Impedance Simulation Networks - Spacecraft DC power systems

Euro 0,00

Quantità

Line Impedance Stabilization Networks are used in many cases to measure the r.f. voltages (from line-
to-ground) conducted on a.c. or d.c. power leads.They establish a known impedance-versus-frequency condition over the frequency range
of interest. These units include an r.f. connector for cabling to an EMI meter or spectrum analyzer to perform the measurement. See catalog page
LINE IMPEDANCE STABILIZATION NETWORKS for details on these units

Disponibilità:

Services and Support

Selint: Line Impedence Networks>